This 18 gauge breathable seamless liner glove offers outstanding dexterity, comfort and cut level C protection.
The micro nitrile foam technology enhances comfort which helps to reduce hand fatigue. The ideal choice for precision handling in dry environments.
EN 420, EN 388:2016
More Portwest Gloves
Features
- CE certified
- 18 gauge liner for extra dexterity
- Highest levels of comfort from foam technology
- Breathable seamless lining ideal for precision handling in dry environments
- ANSI cut level A3
- Level C cut resistance
- Oeko-tex approved
- Free from glass and steel fibres
Materials
UHWPE
Dipping: Nitrile Micro Foam
Product Technical Information
Standards
Documentation
Protective Gloves : General Requirements
EN420 : 2003 + A1 2009
This standard defines the general requirements for glove design and construction, innocuousness, cleaning instructions, electrostatic properties, sizing, dexterity, water vapour transmission and absorption along with marking and information
EN 388
Gloves giving protection from mechanical risks
Protection against mechanical hazards is expressed by a pictogram followed by four numbers (performance levels), each representing test performance against a specific hazard.
1 Resistance to abrasion
Based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the glove. See table below.
2 Blade cut resistance
Based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 4.
3 Tear resistance
Based on the amount of force required to tear the sample.
The protection factor is then indicated on a scale from 1 to 4.
4 Puncture resistance
Based on the amount of force required to pierce the sample with a standard sized point. The protection factor is then indicated on a scale from 1 to 4.
ANSI/ISEA 105-2011
American National a Standard for Hand Protection
This standard addresses the classification and testing of hand protection for specific performance properties related to chemical and industrials applications. Hand protection includes gloves, mittens, partial gloves, or other items covering the hand or a portion of the hand that are intended to provide protection against or resistance to a specific hazard.
